Department of Environmental Quality HomeSearchFeedbackContact UsAccess Idaho
skip nav
About Us
Public Info & Input
Air
Water
Waste
INL Oversight
Maps & Data
Rules & Regs

Return to

Water Quality Standards

 

Contact DEQ

Regional Office
Water Quality Managers

State Office

Water Quality Division

Don Essig

(208) 373-0119

Johnna Sandow

(208) 373-0163


Surface Water Quality Standards: Mixing Zones

 

NEW: Public Comment Period Extended to Dec. 5 on Draft Mixing Zone Guidance

DEQ has developed a draft Mixing Zone Technical Procedures Manual to guide DEQ staff, federal water quality permit writers, and regulated entities on:

• conducting a biological, chemical, and physical appraisal of the receiving water;

• accounting for data limitations;

• determining the appropriate mixing zone model; and

• selecting model input parameters.

DEQ invites public comment on the draft guidance through December 5, 2008.

> Link to draft Mixing Zone Technical Procedures Manual (pdf).

> Submit comment online.

 
 Background

Idaho's mixing zone policy states that after a biological, chemical, and physical appraisal of the receiving water and the proposed discharge, and after consultation with the persons responsible for the wastewater discharge, DEQ will consider the applicability of a mixing zone and, if applicable, its size, configuration, and location.

In defining a mixing zone, several guidelines should be followed, including:

  • The mixing zone should not interfere with existing beneficial uses.
  • Water quality within a mixing zone may exceed chronic water quality criteria so long as chronic water quality criteria are met at the boundary of any approved mixing zone.
  • Acute water quality criteria may be exceeded within a zone of initial dilution inside the mixing zone.
  • The mixing zone may not be acutely toxic to biota significant to the receiving water's aquatic community.
  • The mixing zone should be limited to 25% of the width and volume of the stream to allow a zone of passage for aquatic life.

These guidelines are to be considered in DEQ's determination of the applicability of mixing zones and do not constitute stand-alone regulatory requirements. DEQ is not limited to considering these guidelines in its exercise of discretion implementing the mixing zone policy. For example, narrative requirements that waters be free from toxic substances in amounts that impair beneficial uses also apply in mixing zones.

 
 DEQ's Mixing Zone Implementation Practices

It has been DEQ's practice that if an applicant requests a standard mixing zone that follows the principle limiting the mixing zone to 25% of the width and volume of the stream, DEQ may certify the mixing zone without requiring case-specific justifications from the applicant. If an applicant seeks the use of greater than 25% of the width or volume of a receiving stream, a mixing zone analysis is required before DEQ will certify the mixing zone. DEQ should be consulted early in the planning of a mixing zone analysis so that agreement can be reached concerning the objectives of the analysis, adequacy of existing data, additional data needs, analysis methods, and schedule.

The scope and focus of a mixing zone analysis will depend upon case specific factors. However, the following topics should be included:

  • Background water chemical concentrations
  • Biological conditions in the receiving waters
  • The mixing zone's effect on designated or existing uses of the receiving water or downstream water (demonstration that the mixing zone will not interfere with the designated or existing uses)
  • Acute and chronic toxicity of the effluent
  • The mixing zone's effect on passage of fish or aquatic life in the stream (show that the mixing zone does not interfere with these)
  • Risk of persistent bioconcentrating chemicals in the discharge
  • Relative flows of effluents and receiving waters
  • Physical boundaries at which acute and chronic water quality criteria will be met
  • The mixing zone's and permitted pollutant's effect on threatened or endangered species or habitat (show that the size of the mixing zone and the resulting levels of permitted pollutant in the receiving water would not be likely to jeopardize these)

 
 An Example

DEQ undertook a mixing zone analysis for the Thompson Creek mining mixing zone that evaluated the issues listed above and serves as a good example for others to follow. This report also includes a nondegradation review for special resource waters and an evaluation of the validity of whole effluent toxicity testing to evaluate compliance with Idaho narrative "free from toxicity" water quality standards.

 

 Other Resources

CORMIX is another useful resource for mixing zone analyses. It is an EPA-approved simulation and decision support system for environmental impact assessment of mixing zones resulting from continuous point source discharges. 



  Home | Search | Contact Us |Feedback | About PDF Files | Acronyms | Glossary | State of Idaho | Privacy Notice  
  Copyright © 2000-2008, Idaho Department of Environmental Quality. All rights reserved.